Displaying And Maintaining Bridging Configurations; Transparent Bridging Configuration Examples; Transparent Bridging Over Atm; Transparent Bridging - 3Com MSR 50 Series Configuration Manual

412 C 21: B
HAPTER RIDGING
Displaying and
Maintaining Bridging
Configurations

Transparent Bridging

Configuration
Examples
Transparent Bridging
over ATM
C
ONFIGURATION
Follow these steps to bridge routing:
To do...
Enter system view
Enable bridge routing
Create a bridge-template
interface and enter
bridge-template interface
view
Configure a MAC address for
the bridge-template interface
Return to system view
Configure routing or bridging
of the specified network layer
protocol(s) on bridge set
To do...
View bridge set information
View the statistics information
of a virtual bridge-template
interface
View bridge table information display bridge address-table
View the statistics information
of bridged traffic
Clear bridge table entries
Clear the statistics
information of bridged traffic
Network requirements
As shown in Figure
respectively, which are interconnected through their respective ATM interfaces.
Configure the two routers to enable transparent bridging between the two LAN
segments.
Use the command...
system-view
bridge routing-enable
interface bridge-template
bridge-set
mac-address mac-address
quit
bridge bridge-set routing
{ ip | ipx }
bridge bridge-set bridging
{ ip | ipx | others }
Use the command...
display bridge information
[ bridge-set bridge-set ]
display interface bridge-template
[interface-number]
[ bridge-set bridge-set | dlsw |
interface interface-type
interface-number | mac mac-address]
[ dynamic | static ]
display bridge traffic [ bridge-set
bridge-set | dlsw | interface
interface-type interface-number ]
reset bridge address-table
[ bridge-set bridge-set | dlsw |
interface interface-type
interface-number ]
reset bridge traffic [ bridge-set
bridge-set | dlsw | interface
interface-type interface-number ]
112, LAN 1 and LAN 2 are attached to Router A and Router B
Remarks
-
Required
Disabled by default
Required
No bridge-template interface
configured by default
Optional
-
Optional
By default, routing if network
layer protocols is disabled
Remarks
Available in any
view
Available in any
view
Available in any
view
Available in any
view
Available in user
view
Available in user
view