Displaying And Maintaining Pppoe; Pppoe Configuration Example; Pppoe Server Configuration Example - 3Com MSR 50 Series Configuration Manual

Displaying and
Maintaining PPPoE
PPPoE Configuration
Example
PPPoE Server
Configuration Example
To do...
Terminate a PPPoE session at
the client end and recreate the
session later
Terminate a PPPoE session at
the server end
Terminate a PPPoE session at
the client end and never
recreate it again
To do...
Display statistics and state
information about PPPoE
server sessions.
Display statistics and state
information about PPPoE
client sessions.
Network requirements
In Figure 100, the hosts, acting as PPPoE client, access the Internet through the
router. The router acts as the PPPoE server, performing local authentication and
assigning IP address for the users through address pool.
Network diagram
The router is connected to the Ethernet through the interface Ethernet 1/0 and the
Internet through Serial 2/0.
Figure 100 PPPoE network diagram
Host A
Router
Eth 1 / 0
Host B
Configuration procedure
# Add a PPPoE user

Displaying and Maintaining PPPoE

Use the command...
reset pppoe-client { all |
dial-bundle-number number }
reset pppoe-server { all | interface
interface-type interface-number |
virtual-template number }
undo pppoe-client
dial-bundle-number number
Use the command...
display pppoe-server session { all
| packet }
display pppoe-client session
{ packet | summary }
[ dial-bundle-number number ]
S 2 / 0
Internet
397
Remarks
In user view
In Ethernet interface
view or virtual
Ethernet interface
view
Remarks
Available in any view
Available in any view