3Com MSR 50 Series Configuration Manual page 278

278 C 12: GVRP C
HAPTER ONFIGURATION
Network diagram
Figure 54 Network diagram for GVRP configuration
Eth1/0
Device A
Configuration procedure
1 Configure Device A
# Enable GVRP globally.
<DeviceA> system-view
[DeviceA] gvrp
# Configure port Ethernet 1/0 as a trunk port, allowing all VLANs to pass.
[DeviceA] interface ethernet 1/0
[DeviceA-Ethernet1/0] port link-type trunk
[DeviceA-Ethernet1/0] port trunk permit vlan all
# Enable GVRP on Ethernet 1/0.
[DeviceA-Ethernet1/0] gvrp
# Set the GVRP registration type to fixed on the port.
[DeviceA-Ethernet1/0] gvrp registration fixed
[DeviceA-Ethernet1/0] quit
# Create VLAN 2 (a static VLAN).
[DeviceA] vlan 2
2 Configure Device B
# Enable GVRP globally.
<DeviceB> system-view
[DeviceB] gvrp
# Configure port Ethernet 1/1 as a trunk port, allowing all VLANs to pass.
[DeviceB] interface ethernet 1/1
[DeviceB-Ethernet1/1] port link-type trunk
[DeviceB-Ethernet1/1] port trunk permit vlan all
# Enable GVRP on Ethernet 1/1.
[DeviceB-Ethernet1/1] gvrp
[DeviceB-Ethernet1/0] quit
# Create VLAN 3 (a static VLAN).
[Sysname] vlan 3
3 Verify the configuration
Eth1/1
Device B