3Com MSR 50 Series Configuration Manual page 956

956 C 58: OSPF C
HAPTER ONFIGURATION
[RouterB-ospf-1-area-0.0.0.2] network 10.3.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.2] quit
[RouterB-ospf-1] quit
# Configure RouterC
<RouterC> system-view
[RouterC] ospf
[RouterC-ospf-1] area 1
[RouterC-ospf-1-area-0.0.0.1] network 10.2.1.0 0.0.0.255
[RouterC-ospf-1-area-0.0.0.1] network 10.4.1.0 0.0.0.255
[RouterC-ospf-1-area-0.0.0.1] quit
[RouterC-ospf-1] quit
# Configure RouterD
<RouterD> system-view
[RouterD] ospf
[RouterD-ospf-1] area 2
[RouterD-ospf-1-area-0.0.0.2] network 10.3.1.0 0.0.0.255
[RouterD-ospf-1-area-0.0.0.2] network 10.5.1.0 0.0.0.255
[RouterD-ospf-1-area-0.0.0.2] quit
[RouterD-ospf-1] quit
3 Verify the above configuration
# Display OSPF neighbors information on Router A.[RouterA] display ospf peer
verbose
OSPF Process 1 with Router ID 10.2.1.1
Area 0.0.0.0 interface 10.1.1.1(Ethernet1/0)'s neighbors
Router ID: 10.3.1.1
State: Full
DR: 10.1.1.1
Dead timer due in 37
Neighbor is up for 06:03:59
Authentication Sequence: [ 0 ]
Neighbor state change count: 5
Area 0.0.0.1 interface 10.2.1.1(Ethernet1/1)'s neighbors
Router ID: 10.4.1.1
State: Full
DR: 10.2.1.1
Dead timer due in 32
Neighbor is up for 06:03:12
Authentication Sequence: [ 0 ]
Neighbor state change count: 5
# Display OSPF routing information on RouterA[RouterA] display ospf routing
OSPF Process 1 with Router ID 10.2.1.1
Routing for Network
Destination
10.2.1.0/24
10.3.1.0/24
10.4.1.0/24
10.5.1.0/24
10.1.1.0/24
Neighbors
Address: 10.1.1.2
Mode: Nbr is Master Priority: 1
BDR: 10.1.1.2 MTU: 0
sec
Neighbors
Address: 10.2.1.2
Mode: Nbr is Master Priority: 1
BDR: 10.2.1.2 MTU: 0
sec
Routing Tables
Cost Type NextHop
10 Transit 10.2.1.1
4 Inter 10.1.1.2
13 Stub 10.2.1.2
14 Inter 10.1.1.2
2 Transit 10.1.1.1
GR State: Normal
GR State: Normal
AdvRouter Area
10.2.1.1 0.0.0.1
10.3.1.1 0.0.0.0
10.4.1.1 0.0.0.1
10.3.1.1 0.0.0.0
10.2.1.1 0.0.0.0