3Com MSR 50 Series Configuration Manual page 426

426 C 22: ISDN C
HAPTER ONFIGURATION
To do...
Set the type and code scheme
of calling or called numbers in
incoming or outgoing ISDN
calls
Set the called number of ISDN
interface to send in overlap
mode. In this mode, the digits
of each called number will be
sent separately and the
number of the digits sent
each time can be sent by the
user.
Table 9 Types and code schemes of ISDN numbers
Field (Bit) value
Type
Protocol 8 7
Field (Bit) value
Type
Protocol 8 7
ANSI 0
0
0
AT&T 0
0
0
1
Use the command...
isdn number-property
number-property [ calling |
called ] [ in | out ]
isdn overlap-sending
[digits ]
Code scheme
6 5 4 3 2 1 Definition
Code scheme
6 5 4 3 2 1 Definition
0 0 User-specified
1 0 National network identification
1 1 International network identification
0 0 0 0 Unknown/user-specified
0 0 0 1 Carrier identification code
0 0 1 1 Data network identification code (ITU-T
Recommendation X.121)
0 0 Unknown
0 1 International number
1 0 National number
0 0 Subscriber number
0 0 0 0 Unknown
0 0 0 1 ISDN/telephony numbering loan
(Recommendation E.164/E.163)
1 0 0 1 Private numbering plan
Remarks
Optional
By default, the system selects
ISDN number type and code
scheme depending on upper
layer service. For detailed
information, refer to Table
Optional
In "full-sending" mode, all
the digits of each called
number will be collected and
sent at a time by default.
9.