Displaying And Maintaining Gvrp; Gvrp Configuration Example; Gvrp Configuration Example I - 3Com MSR 50 Series Configuration Manual

276 C 12: GVRP C
HAPTER
Displaying and
Maintaining GVRP
GVRP Configuration
Example
GVRP Configuration
Example I
ONFIGURATION
The setting of each timer must be a multiple of five (in centiseconds).
■
The settings of the timers are correlated. If you fail to set a timer to a certain
■
value, you can try to adjust the settings of the rest timers.
relationship between the timers.
Table 3 Relationship between GARP timers
Timer Lower limit
Hold 10 centiseconds
Join Not less than two times the hold timer
setting
Leave Greater than two times the join timer
setting
LeaveAll Greater than the leave timer setting
To do...
Display statistics about GARP
Display GARP timers for
specified or all ports
Display statistics about GVRP
Display the global GVRP state display gvrp status
Clear the GARP statistics
Network requirements
Configure GVRP for dynamic VLAN information registration and update among
devices, adopting the normal registration mode on ports.
Network diagram
Figure 53 Network diagram for GVRP configuration
Eth1/0
Device A
Configuration procedure
1 Configure Device A
# Enable GVRP globally.
<DeviceA> system-view
[DeviceA] gvrp
Use the command...
display garp statistics
[ interface interface-list ]
display garp timer
[ interface interface-list ]
display gvrp statistics
[ interface interface-list ]
reset garp statistics
[ interface interface-list ]
Eth1/1
Device B
Table 3 shows the
Upper limit
Not greater than half of the join
timer setting
Less than half of the leave timer
setting
Less than the LeaveAll timer
setting
32765 centiseconds
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in user view