Configuring Rip Advanced Functions; Configuring An Additional Routing Metric - 3Com MSR 50 Series Configuration Manual

978 C 59: RIP C
HAPTER
Configuring RIP
Advanced Functions
Configuring an
Additional Routing
Metric
ONFIGURATION
To do...
Specify a global RIP
version
Return to system view
Enter interface view
Specify a RIP version
In some complex network environments, you need to configure advanced RIP
functions.
This section covers the following topics:
"Configuring an Additional Routing Metric" on page 978
■
"Configuring RIP-2 Route Summarization" on page 979
■
"Disabling Host Route Reception" on page 980
■
"Advertising a Default Route" on page 980
■
"Configuring Inbound/Outbound Route Filtering Policies" on page 980
■
"Configuring a Priority for RIP" on page 981
■
"Configuring RIP Route Redistribution" on page 981
■
Before configuring RIP routing feature, finish the following tasks:
Configure an IP address for each interface, and make sure all routers are
■
reachable.
Configure basic RIP functions
■
An additional routing metric can be added to the metric of a RIP route, namely,
the inbound and outbound additional metric.
The outbound additional metric is added to the metric of a sent route, the route's
metric in the routing table is not changed.
The inbound additional metric is added to the metric of a received route before
the route is added into the routing table, so the route's metric is changed.
Follow these steps to configure additional routing metric:
To do...
Enter system view
Use the command...
version { 1 | 2 }
quit
interface interface-type
interface-number
rip version { 1 | 2
[ broadcast | multicast ] }
Use the command...
system-view
Remarks
Optional;
RIP-1 by default;
If an interface has a RIP version
specified, the version takes
precedence over the global one. If no
RIP version is specified for an interface,
the interface can send RIP-1
broadcasts, and receive RIP-1
broadcasts, unicasts, RIP-2 broadcasts,
multicasts and unicasts.
-
--
Optional
Remarks
--