Dcc Application Providing Mp Binding - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
[3Com-luser-usera] password simple usera
[3Com-luser-usera] service-type ppp
[3Com-luser-usera] quit
# Configure Dialer0 interface address and enable RS-DCC.
[3Com] interface dialer 0
[3Com-Dialer0] ip address 122.1.1.2 255.255.255.0
[3Com-Dialer0] undo dialer enable-circular
[3Com-Dialer0] dialer user usera
[3Com-Dialer0] dialer bundle 1
[3Com-Dialer0] dialer number 8810148
# Configure the users that are allowed to dial-up Dialer0 interface, PPP authentication
information and the DCC to the remote end.
[3Com-Dialer0] dialer-group 1
[3Com-Dialer0] ppp authentication-mode pap
[3Com-Dialer0] ppp pap local-user userc password simple userc
# Configure Bri0/0/0 PPP authentication information and the Dialer bundle to which the
interface belongs.
[3Com-Dialer0] interface bri 0/0/0
[3Com-Bri0/0/0] undo dialer enable-circular
[3Com-Bri0/0/0] dialer bundle-member 1
[3Com-Bri0/0/0] link-protocol ppp
[3Com-Bri0/0/0] ppp authentication-mode pap
[3Com-Bri0/0/0] ppp pap local-user usera password simple usera

1.4.2 DCC Application Providing MP Binding

I. Network requirements
The local router is connected to the remote end via two ISDN BRI interfaces. It is
required to set the traffic threshold to distribute the traffic. Thus, the bandwidth
resources can be allocated according to the actual traffic. The maximum available
bandwidth is specified.
As shown in the following figure, the ISDN BRI interfaces on RouterA and the ISDN PRI
interface on RouterB are connected through an ISDN network. RouterA is required to
adopt RS-DCC to call RouterB, and RouterB adopts C-DCC to call RouterA. The
addresses of RouterA and RouterB are respectively 100.1.1.1 and 100.1.1.2.
3Com Corporation
1-44
Chapter 1 DCC Configuration