Rlc Multi-I/O Cable-Enhanced (Ntdr80Xx) - Nortel RLC Installation And Administration Manual

June 2005
RLC Multi-I/O cable–Enhanced (NTDR80xx)
The RLC Multi-I/O cable–Enhanced provides six connections. You can
purchase the RLC Multi-I/O cable–Enhanced separately from Nortel.
Note: Special rules apply if using more than one RLC Multi-I/O cable–
Enhanced in one Meridian 1 PBX 11 cabinet. For further details, contact your
Nortel Network distributor.
The following table describes the connectors of the RLC Multi-I/O cable–
Enhanced:
The
connector
labeled
P1
Note: If you are using a 32-port RLC, insert P1 into the socket for the first of
the two card slots occupied by the RLC.
P2
Note: In North America, P2 requires a DB-15 to RJ-45 converter (shipped
with the cable). Outside North America this plug is a female RJ-45 connector.
P3
P4
Note: In North America, P4 requires a DB-15 to RJ-45 converter (shipped
with the cable). Outside North America this plug is a female RJ-45 connector.
P5
Notes:
Refer to page 13 for an illustration of the RLC Multi-I/O cable–Enhanced.
The illustration on page 15 shows the RLC Multi-I/O cable–Enhanced used
in installations outside North America.
RLC Installation and Administration Guide
that
is a transmits
female 25-pair all signals
connector
male DB-15 10BaseT
connector signaling
female DB-9 RS-232
connector signaling
male DB-15 10BaseT
connector signaling
male 25-pair TCM
connector signaling
Installing the RLC
and connects to the
I/O panel.
CLAN Ethernet
(customer LAN on the network).
serial port to admin PC for
administration and maintenance.
ELAN Ethernet
(host PBX's embedded LAN).
cross-connect to local telephones.
85