Serial Port; Figure 13 Serial Cable (Rj-45-To-Db9); Table 13 10/100Base Ethernet Port Pinouts - Nortel 1010 Series Installing

Table 13 provides the 10/100BASE Ethernet port pinouts for the system ports on
the Contivity 1100.

Table 13 10/100BASE Ethernet port pinouts

TX+ TX- RX+
12345678
CS260010A

Serial port

The system board provides a serial port on the front of the Contivity 1010, 1050,
and 1100 to enable out-of-band management of the gateway. The serial cable
provided with the Contivity 1010, 1050, and 1100 is an RJ-45-to-DB9 cable
(Figure 13). The RJ-45 connector goes into the Contivity 1010, 1050, or 1100, and
the DB9 connector goes into your workstation.
Caution: Use this cable to connect a PC or modem to the Contivity
1010/1050/1100. Do not use this cable to attach a PC or modem to any
other Contivity device.

Figure 13 Serial cable (RJ-45-to-DB9)

Pin 8
RJ-45 connector
Pin
1
RX-
2
3
6
Pin 1
Appendix A Technical specifications 35
Description
TX +
TX -
RX +
RX -
10 ft
(3.05 m)
Pin 5
Pin 9
9-position D-sub receptacle with screw locks
(ground shield connected to backshell)
Installing the Contivity 1010/1050/1100
Pin 1
Pin 6
CAB0110A