Nortel RLC Installation And Administration Manual page 203

June 2005
Field
Date
RLC Extension to Dial
Start DN Discovery
RLC Installation and Administration Guide
Description
Select the date when you want DN Discovery to be performed
(if you selected "Once a month" in the Frequency field).
Use these fields to configure the port number, feature key
position, and DN of the RLC extension to be used for DN
Discovery. At the time configured for DN Discovery, each
remote port on the RLC places a call to the extension described
by these fields. The RLC assigns the incoming Calling Line
Identification (CLID) name and number to the calling port:
Port – This field identifies the port called for DN Discovery.
Note: Nortel recommends that you run DN Discovery on an
unused port, such as a data port, configured with voice
capability. For information on completing this configuration,
refer to the port configuration section of the Remote
Gateway 9150 Installation and Administration Guide (NTP
555-8421-215).
Feature Key – This field identifies the feature key
configured on the host PBX for the port called for DN
Discovery.
DN – This field identifies the DN assigned to the feature key
and port called for DN Discovery.
Click on the Start DN Discovery button to perform an
unscheduled DN Discovery.
Note: Start DN Discovery is available (not dimmed) only if the
configuration in the RLC's Flash memory is the same as the
configuration at the local site, and if the Enable DN Discovery
check box is selected.
Configuring the RLC
177