Configuring Remote And Network Ports; General - Nortel RLC Installation And Administration Manual

June 2005

Configuring remote and network ports

Observe the following rules when configuring remote and network ports for
Remote Gateway 9100 Series systems.

General

Basic Remote Gateway 9100 Series configuration starts with the guidelines
listed in this section.
Configure one remote port for each remote device, such as a digital
telephone or a fax machine, that you want the RLC to support.
Configure at least one network port for each Remote Gateway 9100 Series
unit that you want to support with the RLC.
Note: Each network port provides up to 64K of PSTN bandwidth between the
RLC and the Remote Gateway 9150 unit. To provide 256K of bandwidth
between the RLC and a Remote Gateway 9150 unit, configure four network
ports. For the specific procedure to configure remote and network ports, refer to
the documentation for your PBX.
At your PBX administration terminal, configure voice ports to the appropriate
RLC remote ports supporting remote digital sets using any of the following:
Remote Gateway 9150 units
Remote Gateway 911x units
Digital Telephone Internal IP Adapters
Digital Telephone External IP Adapter
Analog Telephone Adapters (ATAs)
Note: Remote Gateway 911x units do not support ATAs.
RLC Installation and Administration Guide
Configuring the host PBX for the RLC
111