Table of Contents
Advertisement
June 2005
Administration PC
Install the Windows-based RLC administration software on a PC in the Remote
Gateway 9100 Series network. This section describes options for connecting an
administration PC to the RLC. It also describes the hardware and software
requirements of the administration software.
Connection options
The RLC product includes the Configuration Manager software that enables you
to configure, administer, and upgrade the RLC. Perform these tasks over one of
the following connections:
RS-232 serial connection
10BaseT Ethernet connection
Serial connection
Use the serial connection when you first install and configure the RLC. You
must establish a serial connection to the RLC to enter the IP interface
information. Refer to the following illustration:
You can continue using the serial connection for ongoing administration of the
RLC if you prefer.
RLC Installation and Administration Guide
Host PBX
RLC
RS-232 serial connection
(using Configuration Manager software)
Planning for RLC installation
Administration
PC
G101416
67
Advertisement
Table of Contents
Troubleshooting
