June 2005
Reach Line Card LED indicators
The Reach Line Card (RLC) LED indicators give you an indication of the line
card's general health. When you reset your RLC, correct LED indicator behavior
is as follows:
The Maintenance LED behavior upon card insertion:
— lights solid
— flashes three times after completing self-test
Note: The self-test takes approximately 60 seconds.
— goes off after the host PBX enables the RLC
Note: During normal operation of the RLC, the Maintenance LED
remains off.
The remaining LED indicators flash when there is network activity.
RLC Installation and Administration Guide
Troubleshooting
301