Nortel RLC Installation And Administration Manual page 40

RLC description
The following table describes the RLC Multi-I/O cable–Enhanced:
The
connector
labeled
P1
Note: If you are using a 32-port RLC, insert P1 into the socket for the first of
the two card slots occupied by the RLC.
P2
Note: P2 requires an RJ-45 Male to Female converter (already installed).
P3
P4
Note: P4 requires an RJ-45 Male to Female converter (already installed).
P5
The length of this cable, from the termination end of P1 to the termination end of
any other plug, is 0.6 meters (2 feet).
14
that
is a transmits
female 25-pair all signals
connector
male DB-15 10BaseT
connector signaling
female DB-9 RS-232
connector signaling
male DB-15 10BaseT
connector signaling
male 25-pair TCM signaling cross-connect to local telephones.
connector
and connects to the
I/O panel.
CLAN Ethernet
(customer LAN on the network).
serial port to admin PC for
administration and maintenance.
ELAN Ethernet
(host PBX's embedded LAN).
RLC Installation and Administration Guide
Standard 4.0