Table of Contents
Advertisement
June 2005
Security
The RLC offers three security levels. For an explanation of each of these levels,
refer to "Multiple security levels" on page 21.
To configure security for the RLC:
1
Choose the desired security level in the Security Level drop down box on
the Remote Connection Configuration property sheet.
2
If you select Provisioned security, you must also enter a 10-digit Outbound
Security identifier and a 10-digit Inbound Security identifier. To see how
these Security identifiers effect RLC and Remote Gateway 9100 Series
operation, refer to "Multiple security levels" on page 21.
IP connection
To allow a remote unit to establish VoIP connection with the RLC:
1
Enable the VoIP functionality on the IP network for that unit by selecting the
option button located in the Status section.
2
Select the Yes option button located in the IP: Configure section.
3
Enter the unit's IP address in the IP Address fields.
4
Determine the IP Bandwidth using data rate values provided in the
Bandwidth usage table located in the Remote Gateway 9100 Series
Network Engineering Guidelines (NTP 555-8421-103). Calculate the
number of simultaneous calls allowable on your WAN. This depends on the
following information:
compression algorithms used by the call (refer to the table below)
your Wide Area Network (WAN) type
whether Voice Activity Detection (VAD) is enabled or disabled
Compression algorithm
G.711
G.726
G.729A
G.729A/FAX
RLC Installation and Administration Guide
Required voice bandwidth in Kbps
64
32
8
14.4
Configuring the RLC
199
Advertisement
Table of Contents
Troubleshooting
