Nortel RLC Installation And Administration Manual page 233

June 2005
Field
IP: Configure
IP Address
IP Bandwidth
PSTN: Status
RLC Installation and Administration Guide
Description
Select whether you want to allow the RLC to initiate IP
connections to the remote site.
Click on the Yes option button to configure a static IP
address for the remote unit.
Note: The RLC uses this address for connections to the
remote unit.
Click on the No option button if you do not wish to
configure an IP address for the remote unit.
Note: If you select Yes, you must also configure an IP
address for the remote unit.
The default is No.
Enter the remote unit's IP address if you want to be able to
initiate IP connections to the remote site from the RLC.
Enter the total amount of voice bandwidth needed for the
maximum number of simultaneously active telephone calls
over your WAN. When the configured IP Bandwidth limit
is reached, PSTN bandwidth is established. If PSTN is
disabled, then a Bandwidth Limit error message displays
to the user of the Remote Gateway 9150 unit.
This feature does not apply to Remote Gateway 911x
series or Digital Telephone IP Adapter units.
The default is 3136K.
Select whether you want to use the PSTN mode with this
remote unit.
Click on the Enable option button to allow the RLC to
connect to the remote unit over the PSTN.
Click on the Disable option button to prevent the RLC
from connecting to the remote unit over the PSTN.
The default is Disable.
Configuring the RLC
207