Example Of A Network; Sample Configuration Printouts; Configuration Recommendation - Nortel RLC Installation And Administration Manual

Sample configuration files

Example of a network

This section provides an example of a network diagram that shows one host site
(with one RLC installed on the host PBX) and one Remote Gateway 9150 unit
(with one user station). The purpose of this diagram is to demonstrate the
relationship between configuration settings on each unit in the network.

Sample configuration printouts

Sample Meridian 1 PBX configuration printouts for the voice and data ports are
provided as follows:
voice port: on page 354
data port for Remote Gateway 9150 unit: on page 356
data port for Remote Gateway 911x series unit: on page 365
Sample configuration printouts for the RLC, Remote Gateway 9150 unit, and
Remote Gateway 911x series unit are shown as follows:
RLC: on page 367
Remote Gateway 9150 unit: on page 371
Remote Gateway 911x series unit: on page 374

Configuration recommendation

The quickest way to configure the RLC, Remote Gateway 9150 unit, and
Remote Gateway 911x series unit is to run the Configuration Wizard. For
instructions, refer to "Using the Configuration Wizard to perform initial
configuration" on page 92. For your reference, the Configuration Wizard screen
examples are completed using the same information.
Note: The network diagram shows information that cannot be configured
through the Configuration Wizard, such as the security identifiers. You must use
Configuration Manager to complete the configuration.
352 RLC Installation and Administration Guide
Standard 4.0