Table of Contents
Advertisement
June 2005
IF the upload
is successful,
fails,
8
On the Upload Configuration dialog box, click on the Save to Flash button.
Result: The FLASH CONFIG dialog box displays, similar to the following:
9
Click on the Yes button.
Result: The following message displays in the status bar at the bottom of
the screen:
Saving to Flash in Progress
When the save is finished, the following message displays in the middle of
the Upload Configuration dialog box:
CONFIGURATION IS UPDATED INTO FLASH...
10
Click on the Close button.
11
Restart the RLC.
Note: For instructions, refer to "Performing a system restart or shutdown"
on page 161.
RLC Installation and Administration Guide
THEN
the following message displays:
CONFIG UPLOAD SUCCESSFUL... USE
SAVECFG TO UPDATE FLASH.
Proceed to step 8.
the following message displays in the middle of
the Upload Configuration dialog box:
CONFIG UPLOAD FAILED
For further instructions, refer to Chapter 8,
"Troubleshooting".
Administration
247
Advertisement
Table of Contents
Troubleshooting
