Performing A System Restart Or Shutdown; When To Perform A Restart Or Shutdown; Performing A System Restart - Nortel RLC Installation And Administration Manual

June 2005

Performing a system restart or shutdown

Configuration Manager allows you to perform a controlled system restart or
shutdown.

When to perform a restart or shutdown

Each time that you make a configuration change, perform a Save to Flash. You
must also restart the unit if Configuration Manager prompts you to do so.
Note: When you save configuration changes to Flash, the system suspends new
call processing for approximately 30 seconds. Some configuration changes do
not take effect until the unit has been re-started.
You can perform a system shutdown when you need to power the system down.

Performing a system restart

To perform a system restart:
1 From the Menu Bar, choose Connect
Result: The System Restart dialog box displays, similar to the following:
2 Click on the Yes button.
Result: The following status dialog box displays:
The following message also displays in the status bar at the bottom of the
screen:
Restarting the System
RLC Installation and Administration Guide
Using Configuration Manager
→ →
System Reset Restart.
161