To Connect The Mmi Terminal To The Fiber Remote Multi-Ipe Interface; I/O Panel Maint Db-9 Male Connector, Use The Nt7R66Ba Mmi Cable - Nortel CS 1000M HG Manual

Connecting the MMI terminal
An MMI terminal can be directly connected to the Fiber Remote Multi-IPE
Interface unit at the remote site. Refer to
Fiber Remote Multi-IPE Interface unit cable connection diagram" (page 156)
for the connection diagram.
Multiple Fiber Remote Multi-IPE Interface units at the remote site can be
daisy-chained to allow sharing of the MMI terminal among all the Fiber
Remote Multi-IPE Interface units in the chain.
Connecting the MMI terminal to a single Fiber Remote Multi-IPE
Interface unit
An MMI terminal can be directly connected to the remote site Fiber Remote
Multi-IPE Interface unit to provide a maintenance and testing facility for the
Remote IPE and across the fiber-optic link for the local system and the
Fiber Remote Multi-IPE Interface units connected to the local system. One
of the main functions of the MMI terminal at the remote site is to access the
system remotely using the Host SDI mode.
Procedure 24
Connecting the MMI terminal:
Step
1
2
3
Copyright © 2007, Nortel Networks
.
Note: If Fiber Remote Multi-IPE Interface units are daisy-chained
at the remote site, the system monitor address also becomes
the daisy-chain address.
Action

To connect the MMI terminal to the Fiber Remote Multi-IPE Interface

I/O panel MAINT DB-9 male connector, use the NT7R66BA MMI
Cable.
Plug the DB-9 female connector of the NT7R66BA MMI Cable into
the DB-9 male MAINT connector on the Fiber Remote Multi-IPE
Interface unit.
Plug the DB-25 male connector of the NT7R66BA MMI Cable into
the DB-25 female connector on the MMI terminal. If the MMI terminal
does not have a DB-25 connector or is a different gender, use an
appropriate adapter.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 01.01 Standard
Release 5.0 30 May 2007
Remote IPE installation 85
—End—
Figure 17 "Remote site single
—End—