Table of Contents
Advertisement
Planning for RLC installation
4.
When you add three DSP application modules to the 32-port RLC, the line
card has 32 DSP channels. This combination supports up to 32 users,
allowing up to 32 simultaneous calls.
Note: When you add data channel adapters (MCAs and ATAs) to a remote site,
that site's DSP channel usage increases. Every remote call, whether from a
telephone, MCA, or ATA, requires a DSP channel.
Each DSP device configured with the 911x DSP load supports up to four modem
channels.
Installation planning
Make an outline of cable routing between the I/O panel of the shelf where the
RLC resides and the following components of your Remote Gateway 9100
Series system:
your PBX's serial port
the I/O-panel connection to the IOP (input-output port) card for access to
your PBX's internal Ethernet, or ELAN
the cross-connect device to the local telephones using the RLC ports not
providing remote services
Note: The RLC operates properly without the last two connections listed above.
These two connections are available only with the RLC Multi-I/O cable–
Enhanced. Refer to page 12 for more information on this cable.
Deployment planning
Include the configuration settings for each station at each remote site and for
each port at the host site in your deployment plan. Use Appendix A, "Planning
forms", on page 327 to help with this task.
Before you can configure the system with Configuration Manager, you must
configure PBX voice and data ports for each RLC port. Refer to "Configuring
remote and network ports" on page 111.
50
RLC Installation and Administration Guide
Standard 4.0
Advertisement
Table of Contents
Troubleshooting
