Nortel RLC Installation And Administration Manual page 125

June 2005
7 Complete the fields on this dialog box as described in the following table:
Field
Set the Number of
Remote Units
Set the Unit Number of
the Remote unit
Set the Unit ID of the
Remote Unit
Wish to Enable IP Voice
Connection to Remote
RLC Installation and Administration Guide
Description
Enter the number of remote units you plan to
connect to this RLC.
Enter the number that uniquely identifies the
remote unit record you are configuring.
Note: You must give each unit that is
connected to the same RLC a unique unit
record number. Do not confuse this number
with the unit ID (described below).
Enter the number between 1 and 255 that
differentiates the unit being configured from
every other RLC or remote unit in your remote
network.
This number must be different from:
the number assigned to the RLC that this
remote unit connects to
the numbers assigned to other remote units
connected to the same RLC
Click on the Yes option button to enable
voice over IP connection to the Remote
Gateway 9100 Series unit.
Then enter the Remote Gateway 9100
Series unit's 32-bit, decimal dot notation
address (xxx.xxx.xxx.xxx). This is not the
URL (www.) site name.
Click on the No option button to disable
voice over IP connection to the Remote
Gateway 9100 Series unit. Clicking on the
No option button dims the IP Address
fields.
Installing the RLC
99