Table of Contents
Advertisement
June 2005
Configuring Caller ID information
To configure Caller ID information for a Remote Gateway 9150 unit:
1
Access the Remote Connection Configuration property sheet. (Refer to
"Remote connection configuration" on page 197 for help in locating this
property sheet.)
2
Choose the Unit ID of the Remote Gateway 9150 unit that you want to
configure Caller IDs in the Unit ID drop down box, such as 1–20.
Result: 9150 displays in the Unit Type drop down box. If 9150 does not
display in the Unit Type drop down box—if you are completing an offline
configuration, for instance—select 9150 from the available options.
3
Click on the Caller ID button.
Result: The Caller ID configuration sheet displays. (Refer to "List of Caller
IDs" on page 222.)
4
Enter the telephone numbers of the people to whom you want to grant
access to the remote unit in the Caller ID fields.
Note: Enter up to four Caller IDs.
5
Click on the Add button.
Result: The numbers you entered in the fields display in the larger window
below.
6
When you have entered all of the Caller IDs for the ISDN BRI B-channels
assigned to this Remote Gateway 9150 unit, you can configure up to 8,
click on the Close button.
Result: Configuration Manager displays the Remote Connection
Configuration property sheet.
7
Click on the OK button.
Result: Configuration Manager writes the changes to a temporary file on
the administration PC.
8
Click on the Send button to update the RLC with the new information.
Note: To save changes to the RLC's Flash memory, select Upload
to Flash from the Menu Bar.
RLC Installation and Administration Guide
Configuring the RLC
→
Save
223
Advertisement
Table of Contents
Troubleshooting
