Dsp Configuration - Nortel RLC Installation And Administration Manual

Configuring the RLC

DSP configuration

This section shows you how to configure DSP resources on your RLC. The RLC
must provide the same number of voice DSP channels as the maximum number
of simultaneous calls your remote services network supports. Each DSP module
holds two DSP devices. Currently, each DSP device holds four DSP channels.
To add eight DSP channels to your Remote Gateway 9100 Series system's voice
processing capability, add one DSP application module.
Calls made from Remote Gateway 911x series units require two DSP channels
(one voice channel, one modem channel) when operating in PSTN mode. This
includes QoS transitions. If you want to configure Remote Gateway 911x series
units for analog modem calls, you must set the RLC DSPs to Remote Gateway
911x. Each DSP configured for the Remote Gateway 911x series unit supports
four modem only connections (no support for G.711, G.729A, or G.726).
Getting there
DSP Configuration property sheet
224
→
RLC Configuration Manager
→
DSP Configuration
RLC Installation and Administration Guide
Standard 4.0