Installing the RLC
Installing DSP application modules
To install DSP application modules:
1
Clear a flat, static-free work area with sufficient space to hold your RLC and
DSP application modules.
2
Place the DSP application modules in the work area.
Note: Keep the DSP application modules in their antistatic bags.
3
Move the RLC from the host PBX to the work area.
4
Remove a DSP application module from its antistatic bag, holding it by its
edges, with the insertion tabs facing down.
5
Insert the tabs into a pair of expansion slots on the RLC. (Refer to the
illustration on page 6 for location of expansion slots.) The tabs snap into
place when fully inserted. Visually inspect each tab to make sure that there
is no gap and that the tab is fully inserted.
82
RLC Installation and Administration Guide
Standard 4.0