Nortel RLC Installation And Administration Manual page 201

June 2005
Field
Advanced
Configuration
Trunk Support
DSP Gain
RLC Installation and Administration Guide
Description
Click on the Advanced Configuration button to display the
Advanced Configuration dialog box. From this dialog box, you
can to configure the following settings for the RLC:
Dialtone/DTMF Relay to configure whether the PBX or the
Remote Gateway 9100 Series unit generates the dial tone
and DTMF (button-press) tones
Non-Linear Processing (NLP) to configure echo
cancellation settings for calls supported by your Remote
Gateway 9100 Series system
For more information, refer to "Advanced configuration
settings" on page 169.
Configure the speed of your Remote Gateway 9100 Series
connection as follows:
Choose 56K if the speed of your Remote Gateway 9100
Series connection is 56 Kbps.
Choose 64K if the speed of your Remote Gateway 9100
Series connection is 64 Kbps.
Choose Dynamic if your Remote Gateway 9100 Series
connection includes speeds at 56 Kbps and 64 Kbps.
Note: You must configure the same BRI speed (such as 56K,
64K, or dynamic) on both the RLC and the Remote Gateway
9150 unit.
The default is 64K.
Select the number of decibels (dB) that you want to add to, or
subtract from, the strength of the transmitted signal before the
DSP processes it.
Valid options are 9, 6, 3, 0, -3, -6, -9, -12, and -15.
The default is 0 dB.
Note: Change this setting at the Host site to address a problem
with signal strength at the remote site.
Configuring the RLC
175