Nortel RLC Installation And Administration Manual page 38

RLC description
The following table describes the RLC Multi-I/O cable–Basic:
The
connector
labeled
P1
Note: If you are using a 32-port RLC, insert P1 into the socket for the first of
the two card slots occupied by the RLC.
P2
Note: P2 requires a DB-15 to RJ-45 converter (part number 301-00001-01,
shipped with the cable).
P3
The length of this cable, from the termination end of P1 to the termination end of
any other plug, is 0.6 meters (2 feet).
RLC Multi-I/O cable–Enhanced (NTDR80xx)
The RLC Multi-I/O cable–Enhanced allows you to use the RLC's complete
functionality. In addition to the connectivity supplied by the RLC Multi-I/O
cable–Basic (refer to page 11), the RLC Multi-I/O cable–Enhanced adds
connectivity to the host PBX's internal (or embedded) Ethernet for switch
maintenance. With the Enhanced cable you can also service locally connected
telephones through RLC ports not used for remote service purposes.
12
is a that transmits
25-pair all signals
connector
(female)
DB-15 10BaseT
connector signaling
(male)
DB-9 connector RS-232 signaling serial port to admin PC
(female)
and connects to the
I/O panel.
CLAN Ethernet
(customer LAN on the
network).
for administration and
maintenance.
RLC Installation and Administration Guide
Standard 4.0