Table of Contents
Advertisement
Configuring the RLC
Configuring an Online/Offline Table
To configure the Online/Offline Table:
1
Access the Remote Connection Configuration property sheet.
2
Ensure that the Unit ID drop down box shows the Unit ID for the remote unit
you want to configure an Online/Offline Table for. If it does not, choose the
proper Unit ID from the drop down box, such as 1—20.
3
Ensure that the Unit Type drop down box properly reflects the remote unit
you want to configure an Online/Offline Table for. If it does not, choose the
proper Unit Type from the drop down box, such as 9150 or 911X.
4
Click on the Online/Offline button.
Result: The Online/Offline Table dialog box displays. (Refer to "Online/
Offline Table" on page 219.)
5
From the Day drop down box, select the day of the week that you want the
remote unit to have access to the network (PSTN or IP).
6
In the enabled State drop down box, choose Online or Offline, according
to the command you want the system to initiate for this remote site.
Result: Configuration Manager enables the associated Time list box and
the State and Time list boxes immediately below. The chosen state (Online
or Offline) displays in the list box.
Note: If you choose Undefined, the subsequent list boxes remain disabled.
Configuration Manager takes your choice of Undefined to be an indication
that you do not want to configure more commands in this Online/Offline
Table.
7
In the associated Time list box, choose the time (24-hour time format) that
you would like Configuration Manager to initiate the state chosen in step 5.
220
RLC Installation and Administration Guide
Standard 4.0
Advertisement
Table of Contents
Troubleshooting
