Nortel RLC Installation And Administration Manual page 80

Planning for RLC installation
RLC Installation Checklist
Page 3 of 7
✔
Task
2. PBX configuration
❒
Configure the PBX to recognize each
RLC as an XDLC.
❒ Verify that the PBX recognizes each
RLC as an XDLC.
❒
If you want to use the PSTN to route
calls, ensure that ISDN BRI or PRI
trunks are installed and configured on
the PBX for voice and data.
❒
Ensure that there is sufficient capacity
on the trunks for the extra traffic
involved in remote service
operations.
❒
Configure a voice port (or data port
for MCA) on the PBX for each
remote user. (These ports are
associated with Remote ports on the
RLC.)
❒
Configure a data port (or voice port
for 911x modem) on the PBX for
each remote unit connection. (These
ports are associated with Network
ports on the RLC.)
54
For details, refer to
documentation for your PBX.
configuration on your PBX.
configuration on your PBX and
the Remote Gateway 9100
Series Network Engineering
Guidelines (NTP 555-8421-
103).
You can obtain this document
online at the following address:
www.nortel.com
documentation for your PBX.
RLC Installation and Administration Guide
Standard 4.0