Nortel RLC Installation And Administration Manual page 114

Installing the RLC
4 Plug P3, the female DB-9 connector of the RLC Multi-I/O cable (Basic or
Enhanced), into the Remote Gateway 9100 Series administration PC.
IF installing the
RLC Multi-I/O cable–Basic,
RLC Multi-I/O cable–Enhanced in
North America,
RLC Multi-I/O cable–Enhanced in
a location other than North
America,
5 Plug P4, the second male DB-15 connector of the RLC Multi-I/O cable–
Enhanced, into a DB15 to RJ45 adapter (NT7R93CA).
Note: The RLC Multi-I/O cable–Enhanced ships with this adapter. This
adapter is not an active transceiver.
a. Plug one end of a shielded (to meet CISPR B requirements) CAT 5
b. Plug the other end of the CAT5 data cable into your Ethernet hub.
c. Proceed to "Verifying the installation" on page 89.
6 Plug P5, the second 25-pair connector, into the cross-connect device
serving the local telephones that you want to attach to RLC ports not
needed for remote service purposes.
88
data cable of sufficient length to reach your Ethernet hub into the other
side of the DB15 to RJ45 adapter connected to P2.
THEN proceed to
"Verifying the installation" on page
89.
step 5.
step 6.
RLC Installation and Administration Guide
Standard 4.0