Output Config - Agilent Technologies X Series Manual

If you press the Restart key this message will be taken off the screen and a new acquisition will be
attempted; if the External Reference problem persists the message will go right back up. You can also
take the message down by changing back to the
pressing
Freq Ref In, Internal
The setting of External Ref Coupling
is reset to the default state (
restart normal data acquisition.
The detection of invalid external reference is under interrupt processing. If the external reference
becomes invalid then returns to valid in too short a time, no error condition will be detected or reported
and therefore the acquisition will not be stopped.
Key Path
Mode
Remote Command
Preset
State Saved
Readback
Initial S/W Revision

Output Config

Accesses keys that configure various output settings, like the frequency reference output, trigger output
and analog output.
Key Path
Initial S/W Revision
Normal
, or
Freq Ref In, Sense
is persistent across power-cycling and is not reset with a Preset. It
) when
Normal Restore Input/Output Defaults
Input/Output, Freq Ref In
All
[:SENSe]:ROSCillator:COUPling NORMal|NACQuisition
[:SENSe]:ROSCillator:COUPling?
This setting is persistent: it survives power-cycling or a Preset and is reset
with Restore Input/Output defaults.
Not saved in instrument state
Normal|Stop Acq
A.02.00
Input/Output
Prior to A.02.00
setting of Sweep/Ext Ref Coupling, or by
, or
Restore Input/Output Defaults.
is invoked, which will also
Input/Output
457