Agilent Technologies X Series Manual page 617

Title
Displays menu keys that enable you to change or clear a title on your display.
Key Path
Initial S/W Revision
Change Title
Writes a title into the "measurement name" field in the banner, for example, "Swept SA".
Press Change Title to enter a new title through the alpha editor. Press Enter or Return to complete the
entry. Press ESC to cancel the entry and preserve your existing title.
The display title will replace the measurement name. It remains for this measurement until you press
Change Title again, or you recall a state, or a Preset is performed. A title can also be cleared by pressing
, .
Title Clear Title
Notice the inclusion of the <measurement> parameter in the command below.
NOTE
Because each measurement remembers the Display Title, the command must be
qualified with the measurement name. For the Swept SA measurement this is not
the case; for backwards compatibility, no <measurement> parameter is used when
changing the Display Title for the Swept SA measurement.
Key Path
Mode
Remote Command
Example
Notes
Preset
State Saved
Initial S/W Revision
View/Display, Display
Prior to A.02.00
View/Display, Display, Title
All
:DISPlay:<measurement>:ANNotation:TITLe:DATA <string>
:DISPlay:<measurement>:ANNotation:TITLe:DATA?
DISP:ANN:TITL:DATA "This Is My Title"
This example is for the Swept SA measurement in the Spectrum Analyzer
mode. The SANalyzer <measurement> name is not used.
DISP:ACP:ANN:TITL:DATA "This Is My Title"
This example is for Measurements other than Swept SA.
Both set the title to: This Is My Title
Pressing this key cancels any active function.
When a title is edited the previous title remains intact (it is not cleared) and the
cursor goes at the end so that characters can be added or BKSP can be used to
go back over previous characters.
No title (measurement name instead)
Saved in instrument state.
Prior to A.02.00
View/Display
617