Agilent Technologies X Series Manual page 543

Dependencies
State Saved
Readback
Initial S/W Revision
Sweep Type Rules
Selects which set of rules will be used for automatically choosing the Sweep Type when Sweep Type is
in Auto.
Key Path
Remote Command
Dependencies
Preset
State Saved
Initial S/W Revision
Auto
This selection is automatically chosen when Auto Couple is pressed. When in Auto, the Sweep Type
Rules are set to Best Dynamic Range. It seems like a very simple Auto function but the use of this
construct allows a consistent statement about what the Auto Couple key does.
Key Path
Remote Command
Example
Couplings
Preset
State Saved
When a CISPR detector (Quasi Peak, EMI Average, RMS Average) is selected
for any active trace, the FFT key is grayed out.
When Source Mode is set to Tracking, Manual FFT is grayed out.
When Signal ID is on, Manual FFT is grayed out.
Grayed out while in Gated LO (meaning Gate is ON and Gate Method is LO).
Grayed out while in Gated Video (meaning Gate is ON and Gate Method is
Video).
Saved in instrument state
FFT
Prior to A.02.00
Sweep/Control, Sweep Setup
[:SENSe]:SWEep:TYPE:AUTO:RULes SPEed|DRANge
[:SENSe]:SWEep:TYPE:AUTO:RULes?
In Zero Span, this key is irrelevant and cannot be accessed (because the whole
Sweep Setup menu is grayed out in Zero Span), however its settings can be
changed remotely with no error indication.
DRANge
Saved in instrument state
Prior to A.02.00
Sweep/Control, Sweep Setup, Sweep Type Rules
[:SENSe]:SWEep:TYPE:AUTO:RULes:AUTO[:STATe] OFF|ON|0|1
[:SENSe]:SWEep:TYPE:AUTO:RULes:AUTO[:STATe]?
:SWE:TYPE:AUTO:RUL:AUTO ON
Pressing Auto Couple always sets Sweep Type Rules to Auto.
ON
Saved in instrument state
Sweep/Control
543