Agilent Technologies X Series Manual page 176

System Functions
System
Restriction and Notes
Key Path
Mode
Remote Command
Example
State Saved
Restriction and Notes
Restore Align Defaults
Initializes the alignment user interface settings, not alignment data, to the factory default values. Align
Now, All must be executed if the value of the Timebase DAC results in a change.
For front panel operation, you are prompted to confirm action before setting the alignment parameters to
factory defaults:
176
Value is in degrees Centigrade at which the last successful Align Now, 30
MHz – 3.6 GHz was executed.
Visual annotation in the Show Alignment Statistics screen
All
:CALibration:RFPSelector:SCHeduler:TIME:NEXT?
This query returns data using the following format "YYYY/MM/DD;
HH:MM:SS"
:CAL:RFPS:SCH:TIME:NEXT?
No
The next run time will be updated based on the start date/time and recurrence
set by the users.
"date" is representation of the date the task will run in the form of
"YYYY/MM/DD" where:
YYYY is the four digit representation of year. (for example, 2009)
MM is the two digit representation of month. (for example, 01 to 12)
DD is the two digit representation of the day. (for example, 01 to 28, 29, 30 or
31 depending on the month and year)
"time" is a representation of the time of day the task will run in the form of
"HH:MM:SS" where:
HH is the two digit representation of the hour in 24 hour format
MM is the two digit representation of minute
SS is the two digit representation of seconds
For model N9038A only.