Agilent Technologies X Series Manual page 602

Trigger
Example
Preset
State Saved
Range
Initial S/W Revision
Q (Demodulated)
Pressing this key, when it is not selected, selects the main receiver's output Q voltage as the trigger. The
Q (Demodulated) trigger condition is met when the Q voltage crosses the Q voltage trigger level.
Key Path
Example
Readback Text
Initial S/W Revision
Trigger Level
Sets a level for the Q (Demodulated) trigger. When the signal crosses this level, with the chosen slope,
the trigger occurs. If the specific Measurement displays the signal from the chosen sampling point a
green line will be displayed to indicate the trigger level.
Key Path
Remote Command
Example
Preset
State Saved
Range
Readback Text
Initial S/W Revision
Trig Slope
Controls the trigger polarity. It is set positive to trigger on a rising edge and negative to trigger on a
falling edge.
Key Path
602
TRIG:IDEM:DEL 10 ms
TRIG:IDEM:DEL:STAT ON
1 us
OFF
Saved in instrument state
–2.5 s to +10 s
Prior to A.02.00
Trigger, Baseband I/Q
TRIG:<meas>:SOUR QDEM
Q
Prior to A.02.00
Trigger, Baseband I/Q, Q (Demodulated)
:TRIGger[:SEQuence]:QDEMod:LEVel <voltage>
:TRIGger[:SEQuence]:QDEMod:LEVel?
TRIG:QDEM:LEV 0.5 V
0.25 V
Saved in instrument state
–1 to 1 V
0.1 of displayed unit (V, mV, etc.)
Prior to A.02.00
Trigger, Baseband I/Q, Q (Demodulated)