Agilent Technologies X Series Manual page 398

Input/Output
RFIO1
Specifies using the RFIO 1 port, if supported, for the current measurement
Key Path
Example
Dependencies
ReadBack
Initial S/W Revision
RFIO2
Specifies using the RFIO 2 port, if supported, for the current measurement
Key Path
Example
Dependencies
ReadBack
Initial S/W Revision
RF Preselector
In models that support the RF Preselector, such as MXE (N9038A), this key allows you to turn the
preselector on and off.
Key Path
Mode
Remote Command
Example
Example
Notes
Dependencies
398
Input/Output, RF Input, RF Input Port
:FEED:RF:PORT RFIO1
Only available in EXT
RFIO 1
A.05.01
Input/Output, RF Input, RF Input Port
:FEED:RF:PORT RFIO2
Only available in EXT
RFIO 2
A.05.01
Input-Output, RF Setup
All
[:SENSe]:POWer[:RF]: RFPSelector [:STATe] 1|0|ON|OFF
[:SENSe]:POWer[:RF]: RFPSelector [:STATe]?
:POW:RFPS 1
:INP:PRES:STAT ON
[:SENSe]:POWer[:RF]: RFPSelector [:STATe] 1|ON. Sets to full compliance
measurement.
[:SENSe]:POWer[:RF]: RFPSelector [:STATe] 0|OFF. Sets to pre-compliance
measurement.
When the RF Preselector is on, frequencies are limited to keep from sweeping
across the 3.6 GHz boundary. See the Stop frequency key description for an
explanation of that coupling.
This key only appears in models that support the RF Prelselector, in other
models, setting or querying the SCPI will generate an error.