Agilent Technologies X Series Manual page 595

Initial S/W Revision
Reset Offset Display
Resets the value of the periodic trigger offset display setting to 0.0 seconds. The current displayed trigger
location may include an offset value defined with the
currently displayed trigger location as the new trigger point that is 0.0 s offset. The
be used to add offset relative to this new timing.
Key Path
Remote Command
Example
Initial S/W Revision
Sync Source
Selects a signal source for you to synchronize your periodic timer trigger to, otherwise you are triggering
at some arbitrary location in the frame. Synchronization reduces the precision requirements on the
setting of the period.
For convenience you may adjust the level and slope of the selected sync source in a conditional branch
setup menu accessed from the Sync Source menu. Note that these settings match those in the Trigger
and Gate Source menus; that is, each trigger source has only one value of level and slope, regardless of
which menu it is accessed from.
Key Path
Remote Command
Example
Dependencies
Preset
State Saved
Readback
Initial S/W Revision
Modified at S/W Revision
Prior to A.02.00
Offset
Trigger, Periodic Timer
:TRIGger[:SEQuence]:FRAMe:OFFSet:DISPlay:RESet
TRIG:FRAM:OFFS:DISP:RES
Prior to A.02.00
Trigger, Periodic Timer
:TRIGger[:SEQuence]:FRAMe:SYNC
EXTernal1|EXTernal2|RFBurst|OFF
:TRIGger[:SEQuence]:FRAMe:SYNC?
TRIG:FRAM:SYNC EXT2
In some models, there is no second External input. In these models, the
External 2 key is blanked and the EXTernal2 parameter will generate a
"Hardware missing; Not available for this model number" message.
Off
GSM/EDGE: RFBurst
Saved in instrument state
The current setting is read back to this key and it is also Readback to the
previous trigger key.
Periodic Timer
Prior to A.02.00
A.03.00
key. Pressing this key redefines the
Offset
Trigger
key can then
595