Agilent Technologies X Series Manual page 601

Trigger Level
Sets a level for the I (Demodulated) trigger. When the signal crosses this level, with the chosen slope, the
trigger occurs. If the specific Measurement displays the signal from the chosen sampling point a green
line will be displayed to indicate the trigger level.
Key Path
Remote Command
Example
Preset
State Saved
Range
Readback Text
Initial S/W Revision
Trig Slope
Controls the trigger polarity. It is set positive to trigger on a rising edge and negative to trigger on a
falling edge.
Key Path
Remote Command
Example
Preset
State Saved
Initial S/W Revision
Trig Delay
Controls a time delay during which the analyzer will wait to begin a sweep after meeting the trigger
criteria. You can use negative delay to pre-trigger the instrument in time domain or FFT.
Key Path
Remote Command
Trigger, Baseband I/Q, I (Demodulated)
:TRIGger[:SEQuence]:IDEMod:LEVel <voltage>
:TRIGger[:SEQuence]:IDEMod:LEVel?
TRIG:IDEM:LEV 0.5 V
0.25 V
Saved in instrument state
–1 to 1 V
0.1 of displayed unit (V, mV, etc.)
Prior to A.02.00
Trigger, Baseband I/Q, I (Demodulated)
:TRIGger[:SEQuence]:IDEMod:SLOPe POSitive | NEGative
:TRIGger[:SEQuence]:IDEMod:SLOPe?
TRIG:IDEM:SLOP POS
POSitive
Saved in instrument state
Prior to A.02.00
Trigger, Baseband I/Q, I (Demodulated)
:TRIGger[:SEQuence]:IDEMod:DELay <time>
:TRIGger[:SEQuence]:IDEMod:DELay?
:TRIGger[:SEQuence]:IDEMod:DELay:STATe OFF|ON|0|1
:TRIGger[:SEQuence]:IDEMod:DELay:STATe?
Trigger
601