Agilent Technologies X Series Manual page 257

ADC Dither State
Turn the ADC dither on or off. The "ADC dither" function refers to the introduction of noise to the
digitized steps of the analog-to-digital converter, to improve amplitude accuracy.
This is an advanced control that normally does not need to be changed.
Key Path
Mode
Remote Command
Example
Notes
Preset
State Saved
Range
Initial S/W Revision
IF Gain
Opens a menu that allows you to manually select IF Gain settings.
This only applies to the RF input. It does not apply to baseband I/Q input.
Key Path
Initial S/W Revision
IF Gain Auto
Returns manually selected IF Gain settings to the auto (default) setting.
Key Path
Mode
Remote Command
Example
Meas Setup, Advanced, ADC Dither
BASIC
[:SENSe]:SPECtrum:ADC:DITHer[:STATe] ON|OFF|1|0
[:SENSe]:SPECtrum:ADC:DITHer[:STATe]?
SPEC:ADC:DITH 0
SPEC:ADC:DITH?
You must be in the IQ Analyzer (Basic) mode to use this command. Use
INSTrument:SELect to set the mode.
OFF
Saved in instrument state.
On (Best Log Accy)|Off (Best Noise)
Prior to A.02.00
Meas Setup, Advanced
Prior to A.02.00
Meas Setup, Advanced, IF Gain
BASIC
[:SENSe]:SPECtrum:IF:GAIN:AUTO[:STATe] ON|OFF|1|0
[:SENSe]:SPECtrum:IF:GAIN:AUTO[:STATe]?
SPEC:IF:GAIN:AUTO ON
SPEC:IF:GAIN:AUTO?
Complex Spectrum Measurement
Meas Setup
257