Agilent Technologies X Series Manual page 397

Remote Command
Example
Dependencies
Preset
State Saved
Backwards Compatibility SCPI
Initial S/W Revision
Read Back
Backwards Compatibility SCPI
Notes
RF Input
Specifies using the main RF port for the current measurement
Key Path
Example
ReadBack
Initial S/W Revision
RF Input 2
Specifies using the second RF port, if supported, for the current measurement
Key Path
Example
ReadBack
Initial S/W Revision
[:SENSe]:FEED:RF:PORT[:INPut] RFIN|RFIN2|RFIO1|RFIO2
[:SENSe]:FEED:RF:PORT[:INPut]?
:FEED:RF:PORT RFIN
This key only appears in models that support multiple inputs. If the SCPI
command is sent with unsupported parameters in any other model, an error is
generated, –221.1900, "Settings conflict;option not installed"
It is assumed that all models that support multiple inputs will support all
measurements in all modes that ship in those models, unless specifically noted
in the individual Mode or Measurement PD. When any input is selected in a
measurement that does not support it, the "No result; Meas invalid with this
input" error condition occurs, and the measurement should return invalid data
when queried, in whatever way that particular measurement returns invalid
results: not a number, –1000 dBm, –999, etc. This is the responsibility of each
individual measurement.
This is unaffected by Mode Preset but is set to RF on a "Restore Input/Output
Defaults" or "Restore System Defaults -> All"
Saved in State
INPut<1|2>:TYPE INPUT1 | INPUT2
INPut<1|2>:TYPE?
A.05.01
The current RF Input Port selected is read back to this key
The commands above are included for ESU compatibility
Input/Output, RF Input, RF Input Port
:FEED:RF:PORT RFIN
RF Input
A.05.01
Input/Output, RF Input, RF Input Port
:FEED:RF:PORT RFIN2
RF Input 2
A.05.01
Input/Output
397