Agilent Technologies X Series Manual page 427

Example
Notes
Preset
State Saved
Range
Readback Text
Initial S/W Revision
DC
Turns off low frequency rejection, allowing signals down to DC.
Key Path
Example
Initial S/W Revision
LFR1
Turns on low frequency rejection, rejecting signal component lower than 1.7 Hz.
Key Path
Example
Initial S/W Revision
LFR2
Turns on low frequency rejection, rejecting signal component lower than 0.14 Hz.
Key Path
Example
Initial S/W Revision
Set the probe to low frequency rejection below 1.7 Hz.
INP:COUP:I LFR1
Only some probe types support Coupling. For those that do, each probe type
has its own Coupling setting. As probes are changed the Coupling value will
reflect the new probe's setting. Changing the Coupling affects only the current
probe type's setting and leaves all others unchanged.
DC
Saved with probe calibration data. It survives a power cycle and is not affected
by a Preset or Restore.
DC | AC 1.7 Hz LFR1 | AC 0.14 Hz LFR2
DC | LFR1 | LFR2
Prior to A.02.00
Input/Output, I/Q, I Setup | Q Setup, I Probe | Q Probe, Coupling
Turn off low frequency rejection on the I channel
INP:COUP:I DC
Prior to A.02.00
Input/Output, I/Q, I Setup | Q Setup, I Probe | Q Probe, Coupling
Turn on low frequency rejection on the I channel for frequencies lower than
1.7 Hz
INP:COUP:I LFR1
Prior to A.02.00
Input/Output, I/Q, I Setup | Q Setup, I Probe | Q Probe, Coupling
Turn on low frequency rejection on the I channel for frequencies lower than
0.14 Hz
INP:COUP:I LFR2
Prior to A.02.00
Input/Output
427