Agilent Technologies X Series Manual page 440

Input/Output
Mode
Remote Command
Example
Notes
Preset
State Saved
Min
Max
Readback
Initial S/W Revision
Mode
Remote Command
Example
Notes
Preset
Initial S/W Revision
Mode
Remote Command
Example
440
VSA
[:SENSe]:RECording:LENGth <real>,SEConds|RECords|POINts
[:SENSe]:RECording:LENGth:STATe MAX|MANual
[:SENSe]:RECording:LENGth:STATe?
REC:LENG 20,REC
REC:LENG 4.1E–4,SEC
REC:LENG:STAT MAX
REC:LENG:STAT?
There is no default unit. The unit must be specified.
The length command does not have a query form. Length information is
queried using the two commands following this table.
If set to MAX, all of the available "recording memory" us used.
50 Records, Manual
No
0
Depends on memory available.
<value><Seconds|Points|Records>
Prior to A.02.00
VSA
[:SENSe]:RECording:LENGth:VALue?
REC:LENG:VAL?
Query Only
Returns the first (numeric) parameter of the most recent
[:SENSe]:RECording:LENGth command.
50 Records
Prior to A.02.00
VSA
[:SENSe]:RECording:LENGth:UNIT?
REC:LENG:UNIT?