Agilent Technologies X Series Manual page 542

Sweep/Control
Auto
When in Auto, the selection of sweep type is governed by two different sets of rules, depending on
whether you want to optimize for dynamic range or for speed. These rules are chosen under the
Type Rules key.
Key Path
Remote Command
Example
Couplings
Preset
State Saved
Initial S/W Revision
Swept
Manually selects swept analysis, so it cannot change automatically to FFT.
Key Path
Example
Dependencies
Couplings
State Saved
Readback
Initial S/W Revision
Modified at S/W Revision
FFT
Manually selects FFT analysis, so it cannot change automatically to Swept.
Key Path
Example
542
Sweep/Control, Sweep Setup, Sweep Type
[:SENSe]:SWEep:TYPE:AUTO OFF|ON|0|1
[:SENSe]:SWEep:TYPE:AUTO?
:SWE:TYPE:AUTO ON
Pressing Auto Couple always sets Sweep Type to Auto.
Swept is always chosen whenever any form of Signal ID is on, or the Source
Mode is set to Tracking, or any EMI detector is selected.
ON
Saved in instrument state
Prior to A.02.00
Sweep/Control, Sweep Setup, Sweep Type
SWE:TYPE SWE
Grayed out while in Gated FFT (meaning Gate is ON and Gate Method is
FFT).
If this key is selected, the gate method Gated FFT is grayed out.
This selection is chosen automatically if any of the CISPR detectors is chosen
for any active trace, in which case the FFT Sweep Type selection is also
grayed out.
Saved in instrument state
Swept
Prior to A.02.00
A.02.00
Sweep/Control, Sweep Setup, Sweep Type
SWE:TYPE FFT
Sweep