Agilent Technologies X Series Manual page 585

Remote Command
Example
Couplings
Preset
State Saved
Min
Max
Default Unit
Initial S/W Revision
Trig Slope
Controls the trigger polarity. It is set positive to trigger on a rising edge and negative to trigger on a
falling edge.
Key Path
Remote Command
Example
Couplings
Preset
State Saved
Backwards Compatibility SCPI
Initial S/W Revision
Trig Delay
Controls a time delay during which the analyzer will wait to begin a sweep after meeting the trigger
criteria. You can use negative delay to pre-trigger the instrument in time domain or FFT, but not in swept
spans.
Key Path
:TRIGger[:SEQuence]:EXTernal2:LEVel
:TRIGger[:SEQuence]:EXTernal2:LEVel?
TRIG:EXT2:LEV 1.1 V
This same level is used for the Ext2 trigger source in the Trigger menu, for the
Ext2 selection in the Periodic Timer sync source (in the Trigger menu and in
the Gate Source menu), and also for the Ext2 selection in the Gate Source
menu.
1.2 V
Saved in instrument state
–5 V
5 V
V
Prior to A.02.00
Trigger, External 2
:TRIGger[:SEQuence]:EXTernal2:SLOPe POSitive|NEGative
:TRIGger[:SEQuence]:EXTernal2:SLOPe?
TRIG:EXT2:SLOP NEG
This same slope is used in the Ext2 selection for the trigger source in the
Trigger menu and for the period timer sync source (in the Trigger menu and in
the Gate Source menu).
POSitive
Saved in instrument state
Also, there are SLOPe backward compatibility commands described in Video,
section :TRIGger[:SEQuence]:SLOPe
Prior to A.02.00
Trigger, External 2
Trigger
585