Agilent Technologies X Series Manual page 443

Properties
Accesses a menu that lets you set the properties of the selected correction.
Key Path
Initial S/W Revision
Select Correction
Specifies the selected correction. The term "selected correction" is used throughout this document to
specify which correction will be affected by the functions.
Key Path
Notes
Preset
Readback
Initial S/W Revision
Antenna Unit
For devices (like antennae) which make measurements of field strength or flux density, the correction
array should contain within its values the appropriate conversion factors such that, when the data on the
analyzer is presented in dBμV, the display is calibrated in the appropriate units. The "Antenna Unit" used
for the conversion is contained within the corrections array database. It may be specified by the user or
loaded in from an external file or SCPI.
When an array with an Antenna Unit other than "None" is turned on, the Y Axis Unit of the analyzer is
forced to that unit. When this array is turned on, and it contains an Antenna Unit other than "None", the
Y Axis Unit of the analyzer is forced to that Antenna Unit., and all other Y Axis Unit choices are grayed
out.
Antenna Unit does not appear in all Modes that support Corrections. Only the modes listed in the Mode
row of the table below support Antenna Units.
Key Path
Mode
Remote Command
Example
Input/Output, Corrections
A.02.00
Input/Output, Corrections, Properties
The selected correction is remembered even when not in the correction menu.
Set to Correction 1 by Restore Input/Output Defaults.
Correction 1|Correction 2|Correction 3|Correction 4|Correction 5|Correction 6
A.02.00
Input/Output, Corrections, Properties
SA
[:SENSe]:CORRection:CSET[1]|2|3|4:ANTenna[:UNIT]
GAUSs|PTESla|UVM|UAM|NOConversion
[:SENSe]:CORRection:CSET[1]|2|3|4:ANTenna[:UNIT]?
CORR:CSET:ANT GAUS
Input/Output
443