Agilent Technologies X Series Manual page 134

System Functions
Save
The default path for all State Files including .trace files is:
My Documents\<mode name>\state
where <mode name> is the parameter used to select the mode with the INST:SEL command (for
example, SA for the Spectrum Analyzer).
When you first enter this dialog, the path in the Save In: field depends on the data type. The only files
that are visible are the *.trace files and the Save As type is *.trace, since .trace is the file suffix for the
Trace Save Type.
Key Path
Mode
Notes
Initial S/W Revision
Save
This key initiates the save of the .trace file. All of the State of the currently active mode plus the system
level Input/Output settings are saved to the specified file as well as all of the trace data, including
internal flags set in the file indicating which trace is to be saved.
While the save is being performed, the floppy icon shows up in the settings bar near the
Continuous/Single sweep icon. After the save completes, the Advisory Event "File <register number>
saved" is displayed.
Key Path
Mode
Remote Command
Example
134
Save, Trace (+State)
SA
Brings up the Save As dialog for saving a Trace Save Type
Prior to A.02.00
Save, Trace, Save As...
SA
:MMEMory:STORe:TRACe
TRACE1|TRACE2|TRACE3|TRACE4|TRACE5|TRACE6|ALL,<filename
>
:MMEMory:STORe:TRACe:REGister
TRACE1|TRACE2|TRACE3|TRACE4|TRACE5|TRACE6|ALL,<integer>
:MMEM:STOR:TRAC TRACE1,"myState.trace" saves the file myState.trace
on the default path and flags it as a "single trace" file with Trace 1 as the
single trace (even though all of the traces are in fact stored).
:MMEM:STOR:TRAC ALL,"myState.trace" saves the file myState.trace on
the default path and flags it as an "all traces" file
:MMEM:STOR:TRAC:REG TRACE1,2 stores trace 1 data in trace register 2