Trigger
Initial S/W Revision
Trigger Center Frequency
This key sets the center frequency to be used by the auxiliary receiver.
Key Path
Remote Command
Example
Notes
Preset
State Saved
Range
Initial S/W Revision
Trigger Bandwidth
This key sets the information bandwidth used by the auxiliary receiver for the Auxiliary Channel I/Q
Magnitude trigger.
Key Path
Remote Command
Example
Notes
Preset
State Saved
608
Prior to A.02.00
Trigger, Baseband I/Q, Aux Channel I/Q Mag
:TRIGger[:SEQuence]:AIQMag:CENTer <freq>
:TRIGger[:SEQuence]:AIQMag:CENTer?
:TRIG:AIQM:CENT 10 MHz
Trigger CF + 1/2 Trigger BW < Max
Trigger CF – 1/2 Trigger BW > Min
0 Hz
Saved in instrument state
–40 MHz to 40 MHz
Prior to A.02.00
Trigger, Baseband I/Q, Aux Channel I/Q Mag
:TRIGger[:SEQuence]:AIQMag:BANDwidth <freq>
:TRIGger[:SEQuence]:AIQMag:BANDwidth?
:TRIG:AIQM:BAND 8 MHz
The combined sample rate for the main and auxiliary receivers cannot exceed
100 MSa/sec. The bandwidth available to the Trigger BW is limited to what is
available after the main receiver's bandwidth (Info BW, sometimes pre-FFT
BW) is set. Because of this limitation, the Max is not always achievable.
The combination of Trigger Center Freq and Trigger BW is also limited:
Trigger CF + 1/2 Trigger BW < Max
Trigger CF – 1/2 Trigger BW > Min
Bandwidth option dependent:
No Opt: 10 MHz
Opt B25: 25 MHz
Opt S40: 40 MHz
Saved in instrument state