Agilent Technologies X Series Manual page 467

Off
Turns off the signal at the Cal Out port. This choice is only available with option BBA.
Key Path
Readback
Initial S/W Revision
Digital Bus
This menu allows you to configure the LVDS connector located on the rear panel of the instrument. It is
a unidirectional link of real time data at a 90 MSa/s rate. The ADC is sampling a 22.5 MHz IF.
The data that appears on this port is raw, uncorrected ADC samples, unless you have option RTL. With
option RTL, you get fully corrected I/Q data.
This connector will only be active when the Narrowband IF Path is currently in use.
Key Path
Initial S/W Revision
Bus Out On/Off
When Bus Out is on, all acquisitions are streamed to the output port including acquisitions for internal
purposes such as Alignment; internal processing and routing of acquisitions continues as usual and is
unaffected by the state of Bus Out.
When Bus Out is off, no signal appears on the LVDS port.
Key Path
Scope
Remote Command
Example
Preset
State Saved
Initial S/W Revision
Modified at S/W Revision
Input/Output, Output Config, I/Q Cal Out
Off
Prior to A.02.00
Input/Output, Output Config, Digital Out
A.04.00
Input/Output, Output Config, Digital Out, Digital Bus
Mode Global
:OUTPut:DBUS[1][:STATe] ON|OFF|1|0
:OUTPut:DBUS[1][:STATe]?
OUTP:DBUS ON
This is unaffected by a Preset but is set to Off on a "Restore Input/Output
Defaults" or "Restore System Defaults -> All"
Saved in Input/Output State
Prior to A.02.00
A.04.00
Input/Output
467