Agilent Technologies X Series Manual page 597

Readback
Initial S/W Revision
Modified at S/W Revision
Trigger Level
Sets the value where the signal at the external 2 trigger input will synchronize with the periodic timer trigger. This
same level is used in the Ext2 trigger source in the Trigger menu. See section
information on this key and the SCPI command.
Trig Slope
Controls the trigger polarity. It is set positive to trigger on a rising edge and negative to trigger on a falling edge.
This same value is used in the Ext2 trigger source in the Trigger menu. See section
information on this key and the SCPI command
RF Burst
Pressing the key once selects the RF burst envelope signal to be used for the periodic timer trigger
synchronization.
Press the key a second time to access the RF burst sync source setup menu.
Key Path
Example
Couplings
Readback
Initial S/W Revision
Trigger Level
Sets the trigger level to be used for the RF Burst trigger. This same level is used in the RF Burst trigger source in
the Trigger menu. See section
command.
Trig Slope
Controls the RF Burst trigger polarity. It is set positive to trigger on a rising edge and negative to trigger on a falling
edge. This same value is used in the RF Burst trigger source in the Trigger menu. See section
page 589 for information on this key and the SCPI command
Trig Delay
This setting delays the measurement timing relative to the Periodic Timer.
Key Path
External 2
Prior to A.02.00
A.03.00
Trigger, Periodic Timer, Sync Source
TRIG:FRAM:SYNC RFB
Same as RF Burst trigger source.
RF Burst
Prior to A.02.00
"Absolute Trigger Level" on page 587
Trigger, Periodic Timer
"Trigger Level " on page 584
"Trig Slope " on page 585
for information on this key and the SCPI
"Trigger Slope " on
Trigger
for
for
597